久久久久久久精品免费看,欧美激情无线码,中文字幕日本免费观看视频,成人区精品一区二区三区,av在线免费观看18,色综合欧美色综合七久久,99视频在线观看视频,国产偷自拍视频区视频,成人在线免费观看视频播放

濟南皓暉建材電梯門套廠家分享電梯門套的安裝步驟，下面就給大家詳細分享。
Jinan hao CDH building materials manufacturer of elevator door cover share the elevator door cover installation steps, the following details to share to everyone.
第一、電梯門套表面需要簡單處理，表面應干燥，含水不大于8%。

First, the elevator door cover surface need simple processing, surface should be dry, water cut is not greater than 8%.

第二、石電梯門套安裝前先挑選好的材質。
Second, the elevator door cover to choose good material before installation.
第三、對安裝的結構表面清理，放水平線、垂直線。
Third, cleaning the surface of the structure of installation, put in vertical and horizontal.
第四、用臺鉆打眼、每塊板上、下打眼，孔位打在板中間，孔徑為 8毫米，深度為12毫米。
Fourth, with bench drill, and punch a hole on every board, the drilling, hole location in the middle of the plate, the aperture is 8 millimeter, depth of 12 mm.
第五、用膨脹螺栓把角架固定，再把掛件固定在角架上。

Fifth, with the expansion bolt cover the fixed frame, again to hang on the Angle of the rack.

第六、電梯門套開槽，用云石膠把其固定在掛件上。
Sixth, the elevator door cover slot of the fixed with marble glue on the pendant.
第七、立面垂直，光面平整，接縫平直，接縫寬度，偏差允許2毫米。
Seventh, vertical elevation, smooth level off, the seam straight, seam width, 2 mm deviation allowed.

第八、全部安裝完后，要對電梯門套表面一次性清潔干凈。

Eighth, after the installation, all one-time clean to the elevator door cover surface.